Bead Bracelet Update

I have already made an Instructables on this bracelet, but the pictures were blurry and unclear, so I have decided to update it. I hope you like this bracelet, so enjoy=)

For this bracelet, you will need...
•Any Loom
•Look Pick or Crochet Needle
•Rubber Bands
•S-Clip or C-Clip

To begin, take a single band and place as shown. Take another single band and place as shown. You will be using single bands during this whole bracelet.

Using single bands, go down on both sides of your loom, leaving the last peg on both sides alone.

Using single bands, close off the bracelet as shown.

Using any color of your choice, go down the center of your loom with single bands.

For this step, you can either use loom bands or beads. To make a loom bead, wrap a single band around your hook four to five (4-5) times. Then slide that band onto a single band. Place on your loom as shown. If you would like to use beads, slide a single band through your bead and place as shown.

Make more beads of your choice and place as shown.

Take a single band and wrap it around the last peg in the center once, creating two loops as shown.

To begin looming, go inside of your cap band and grab the top band, which will go forward. Then go inside again, grabbing the next band, which will go to your right. Go inside one last time, grabbing the last band that will go to your left.

Loom down the center all the way to the top as shown.

Loom the left side of your loom as shown.

Loom the right side as shown.

Loom the top as shown.

Leaving your bracelet the way as it is would be bad because it would cut off the blood circulation to your hand when worn, so you have to make an extension. To do this, go inside all of the bands shown, pulling a single band through them. Then pull a single band through that band as shown. Repeat this step until your bracelet can fit your wrist.

Put your clip on your bracelet as shown.

Pull your bracelet off your loom and take a look. The bracelet will look messy, put pull and push and tease and your bracelet will look better=)

Clip your clip to the end of your bracelet as shown.