Collar + Leash

Great DIY pet sewing project for all skill levels! They make for a great gift! Make your pets matching collar and leash sets for every occasion! What are you waiting for! Hope everyone has fun with this sewing project!

-LINK to Webbing (Rainbow): https://amzn.to/2Sj9P1r

-LINK to Buckles: https://amzn.to/3gl7URO

-LINK to Webbing Slide: https://amzn.to/3wh2Q7R

-LINK to D-Rings Set: https://amzn.to/3whacYO

-LINK to Double Sided Rivets: https://amzn.to/34vhUT3

-LINK to Hand Press: https://amzn.to/3fQsx8h

-LINK to Sewing machine Singer 4423 https://goo.gl/33eHF8

Webbing: 2 yards (pick width that best fits your pet)

Buckles: 1 (match webbing width)

Webbing Slide: 1 (match webbing width)

D-Rings: 2 (match webbing width and 1 smaller one for tag holder)

-Measure around your pets neck.

-Add 3-4 inches to neck measurement.

-Cut webbing for collar.

-Remember to add 3-4 inches to length.

-Light webbing ends to prevent fraying/unraveling.

-Add webbing slider to webbing.

-Slide slider 6-7 inches down webbing.

-Feed webbing from the bottom. Start going up through the outside opening and back down through the inside opening.

-Pull webbing end out 5 inches after feeding though buckle.

-Slide webbing end up though the outside hole of webbing slider.

-Feed end back down though inside opening of webbing slider.

-Pull end out about 2 inches.

-Stitch webbing end down 2 inches from webbing slider.

-I recommend zig zag stitch or very tight tac stitch. Make sure end is securely fastened down.

-Add D-Ring to opposite end of buckle.

-Slide webbing end though the remaining buckle opening from top to bottom.

-Pull webbing end out about 4 inches and roll the end over for clean finish.

-Make sure D-Ring is placed in the middle of webbing end and buckle.

-Stitch on both sides of the D-Ring.

-I recommend going back and forth a few times. This will add a nice strong stitch.

-Grab D-Ring that is smaller width than the webbing.

-You can either use smaller webbing or leather strips to fasten down D-Ring.

WEBBING OPTION

-Cut 3 inch strip of webbing.

-Feed D-Ring on strip.

-Roll webbing ends over for clean finish.

-Sew webbing strip onto collar.

LEATHER OPTION

-Cut leather strip.

-Punch holes in leather.

-Feed D-Ring on strip.

-Fasten to collar with double sided rivets.

Collar is complete! :)

-Cut leash to desired length.

-Add 12 inches to desired length for handle and eye snap attachment.

-Feed webbing though swivel eye snap opening.

-Pull out 4 inches.

-Roll and tuck end under 2 inches.

-Stitch in box or X formation.

-Make sure you stitch down really good. This end will be taking a lot of strain.

-On the opposite end of leash. Measure down 8 inches and roll end over.

-Roll end over 2 inches for clean finish.

-Stitch handle down in box of X formation.

-Make sure you sew over the rolled end for maximum strength.

-Cut leather or webbing strip.

-Place directly under handle.

-Sew or fasten down with double sided rivets.

-This is a quick and easy way to clip extras items to leash.

You are all finished! Hopefully this was easy to follow. Feel free to check out the detailed video tutorial if you have trouble with any of the steps. :)