Computer Expansion Deluxe

Hello, my name is Donovan and today I will be talking about the computer expansion deluxe, and how I made it.

1. Box
2. Different switches
3. Outlet connector switcher (male)
4. Phone camera
5. Ring light
6. Tap (silver)
7. Pocket Knife

My first step for my project was to measure out the holes for each individual facing switch panel to see how the front would fit on the front of my box. After I made sure each panel facing would fit on the front of the box and picked which ones I wanted on the box I then continued with wrapping my box with the sliver tape.

(PS you can use any tape you want)

Step two is you want to start cutting out all your previously measured holes with your pocket knife and start deconstructing your computer or other such components. To get the facing panel off or The buttons/switch panels.

In This step three, I will measure and cut where the cord is going to be (right side of the box).

Then I cut a whole for the camera (the placing of the camera is your choice)

Add both to designated place and connect with silver tape.

In step four, I collected all of the photos that I needed for my project with my phone

Before Chat-GPT

I got my original photos and asked Chat-GPT to clean up the edges and make everything look straight and add a different background. I asked it to put it on Table.

After Chat-GPT