Cutting Board by Tyler Watson

In this instructable I talk about how I made a cutting board and how I made it.

Wood, Sander, Plainer, Table saw, Mineral Oil, Edge cutter? Laser engraving machine.

I used fusion360 to design my overall cutting board online. I used the dimensions of 2 inches wide and 12 inches long on the board.

I used 3 pieces of walnut wood and 2 pieces of maple. My two pieces of maple were 1 inch each and my two pieces of walnut at the edges were 1 inch as well and my walnut in the middle was 2 inch inches wide and 12 inches long.

In my third step I would glue the wood together.

,.m,I would plain the wood on each side till it gets rid of the bumps and make it smooth.

I used 100 to send my board .

We used the laser engraving machine to engrave my design on my cutting board.

We put mineral oil on the board so it would be nice.

I am finally done with the damn board after my first was stolen and had to make a new one. Hopefully I get a good GRADE MR.B 😎