DIY Pallet Workbench

I needed a workbench so I could stop using my animal trap as a workbench

materials

1. one maybe two pallets
2. two six foot pieces of wood (i don't know what to call them)
3. lots of nails

tools

1. drill
2. a way to take apart the pallet

take the all of the boards (except the end boards) off the top of the pallet without breaking them

I don't have a prybar or any way to take the pallet apart without damaging it so I tried a few things........

1. drill the nails out: an okay way to take it apart but time consuming
2. use purchase with a 2x4: the 2x4 broke
3. hammer a screw driver under the nails: doesn't work very well
4. get some cinder blocks, put them through the spaces and jump on it : I ended up cracking the pallet and breaking another board
5. get two hammers and try too pry the nails out: success! why i didn't do this in the first place: the nails were too far nailed in

push the boards (that you took off earlier) to one side of the pallet and screw them in NOTE: you will not have enough boards to cover the top so take off the bottom boards and screw them in

cut the six foot boards in half

screw the boards to the underside corners

I screwed three screws to the side that had a vertical board and toenailed the other side do this to all of the boards

when I put the table on its legs it was kinda wobbly so I added side covers!

now go build something on it!