Differential Amplifier, MiniPCB, 04B-360, Rev A1-02

I made a Differential Amplifier with a gain of approximately 30!

The PCB is a two layer board, and designed to be easy to manufacture and assemble. And it is optimized for cost by being panelized on 100 x 100 mm squares.

Signals are routed on the bottom layer (the layer with the part number), and a common ground plane (as uncut as possible) is on the top layer.

The P1 connector is located in a standard position with respect to the board edges: making it possible to build a universal tester, backplane, or stand.

For ease, start with the shortest components.

If a potentiometer is installed with pin 1 in the wrong place, adjustment procedure will be inverted (CW/CCW).

I need to make an interface board specifically for testing differential amplifiers. But I was able to make 00A-012 work.