How to Install Laser Head for IDraw Pen Plotter
by uunatek in Workshop > Laser Cutting
763 Views, 2 Favorites, 0 Comments
How to Install Laser Head for IDraw Pen Plotter
After you assembled the iDraw Pen plotter, you can unlock more fun by installed the laser head, which can laser on wood, paper, leather and more. This laser head is only 500wm, check more detail about the laser head here
Make Sure You Got All Laser Head Parts
Untighten the End Block on the Small Axis by Using the Provided Allen Key.
Install the Laser Head in the Other End of the Rods
Connect the Laser Head to the Motherboard
Set Up the Laser Power On
Open the software, which is downloaded online here, open Extensions->AxiDraw Control-> Setup->Laser Power on
Adjust the Laser With the Protective Glasses, Make Sure It's Focused on the Surface
Set Up the Writing/drawing Speed Into 5
Cause it takes time to laser on wood, paper or leather, you need to set up the writing/drawing speed from default 25 into 5.
Done! You Can Start to Laser Now!