Hymn of the Dead

This is my all time favorite thing I've created. The bolt works and can be used very quickly

The broken pieces in this step cannot be substituted

Picture 1 is what will be made

Pictures 6, 7, and 8 are all in pictures 9

Picture 9 will be added in picture 15

The broken pieces used in this step cannot be substituted

Picture 1 is what will be made

The white rod in pictures 5 is essential and should not be forgotten

The extra 2 parts in picture 6 are added in pictures 11 and 13

After picture 24 add the other side and the lower receiver is complete

Picture 1 is what will be made

Pictures 6, 7, and 8 must be in this order and fashion in order for the magazine to stay in properly

Picture 1 is what will be made

The orange connectors in picture 3 are not necessary

In picture 4 the white rod is in between the two connectors

The white rod used in picture 9 from picture 8 is not necessary

Picture 1 is what will be made

There are 14 grey two way connectors in picture 8

Pictures 15-17 are for comfort only and are not necessary

Picture 1 is what will be made

There are 13 3 way connectors in pictures 8 and 8

The spacers added in pictures 12 and 13 should not be there

The magazine can be extended downward for a higher capacity magazine

Picture 1 is what will be made

The broken rods in pictures 3 and 4 are the only ones necessary, the rest are for support and are not needed

Picture 1 is all the parts

Pictures 2-5 are connecting the upper receiver to the lower receiver

Pictures 6 and 7 are connecting the receiver to the barrel

Pictures 8 and 9 are connecting the handle to the receiver

Picture 10 is connecting the handle to the trigger guard

Pictures 11-15 are connecting the stock to the lower receiver and the handle

Pictures 16-20 are connecting the bolt mechanism to the upper receiver and the stock

Picture 1 is a small rubber band on the trigger

Picture 2 is the rubber band used for the ramrod in pictures 3 and 4

Pictures 1-3 are showing how to put the magazine in. Once the magazine is angled in as shown in picture 2, just apply pressure upward and the magazine will slide in. To take the magazine out just pull it forward and down

To shoot, pull the bolt back as shown in picture 5, then pull the bolt back forward as shown in picture 6 then the gun is ready to fire

I hope you enjoy my creation. If you have any questions or comments feel free to drop them in the comments section and I'll get to them as quickly as I can