Knex Ball Machine Element: KHAOS

Hey everyone,

Here are instructions for my biggest, most complicated element so far. This element is almost a ball machine on it's own. I wanted to call it KHAOS because it uses 4 knex balls at the same time and it's hard to understand whats going on. So if you want to know how it works you'll have to watch the video. On top of the element there are 3 separators that needs to be in a specific position so the knex balls can be devided correctly, which is explaned at the end of the instructions. It consumes a lot of pieces and works about 90% of the time. You'll need 2 special pieces to complete this build (see step 1).

If there are any problems/ questions feel free to ask me in the comments below.

Thanks for watching/ building,

Thibault Art.

You only need 1 of the black one, and a few of the orange one.

Make sure the arm is leaning to the right.

Make sure the separators are in this position.

Make sure the red connector holds the track all the way up.

Make sure when the arm falls to the other side that it hits the grey connectors.

Make sure the grey connector is on the right side.

Make sure the yellow rod is between the 2 grey connectors.

5 knex balls are needed.

Place 1 ball on yhe little handle like this.

Put 4 knex balls on the track of the separators.

At the end 3 knex balls should roll out the element and the other 2 balls should end up like showed on the second picture. If not, tell me in the comments whats wrong and I'll help you as soon as possible :).