Leather Thumb Drive Case

A travel case for 4 usb thumb drives made from leather.

1. Scrap Leather

2. Leather Punch

3. Pen

4. Scissors

5. Velcro

6. Rivets

7. Hot Glue Gun

8. Key ring with clip

NOTE: This travel case is for 4 thumb drives

Cut out two 3 1/2" squares of leather

Next, Cut a 3 1/2" X 2 1/2" strip of leather for the connecting piece

After that, on the 3 1/2" pieces find the middle and mark with a pen

Cut out two 2 1/4" X 5" strips of leather and three holes on the sides and middle.

Punch holes on the 3 1/2" squares with the photos

I punches 5 holes along the sides and three to fit the 2 1/4" piece from earlier.

On the 2 1/2" strip punch 5 holes to fit the square pieces

Rivet together the pieces

Once riveted together flip the leather.

Take the 5" X 2 1/4" and rivet it to the square pieces bending it to make pockets with rivets

Hot glue the bottom of the pockets so the thumb drives don't fall out

On the inside, take the pin and mark where you would like the ring to be placed

Punch holes with the leather punch and loop the ring through

Take two velcro squares and stick them to the pockets

Check to see if they stick together right

Check to see if everything lines up and use your thumb drive!

Enjoy your carrying case!