Masquerade Mask With Hot Glue
by Bhawya in Craft > Costumes & Cosplay
2375 Views, 21 Favorites, 0 Comments
Masquerade Mask With Hot Glue
![DSCN0119.JPG](/proxy/?url=https://content.instructables.com/F90/ZT5Z/I1C3VTT4/F90ZT5ZI1C3VTT4.jpg&filename=DSCN0119.JPG)
![DSCN0120.JPG](/proxy/?url=https://content.instructables.com/FMC/CHS9/I1C3VTT7/FMCCHS9I1C3VTT7.jpg&filename=DSCN0120.JPG)
![DSCN0117.JPG](/proxy/?url=https://content.instructables.com/F1N/5DCC/I1C3VTP8/F1N5DCCI1C3VTP8.jpg&filename=DSCN0117.JPG)
![DSCN0118.JPG](/proxy/?url=https://content.instructables.com/FRN/OOHI/I1C3VTR8/FRNOOHII1C3VTR8.jpg&filename=DSCN0118.JPG)
![544061bc26ece2cbaf000008.jpeg](/proxy/?url=https://content.instructables.com/FT1/0MG2/I1C3XHHZ/FT10MG2I1C3XHHZ.jpg&filename=544061bc26ece2cbaf000008.jpeg)
It is super quick and super easy Mask.
Supplies
![DSCN0052.JPG](/proxy/?url=https://content.instructables.com/FUM/C4CW/I1C3WIZZ/FUMC4CWI1C3WIZZ.jpg&filename=DSCN0052.JPG)
Hot glue gun
Glue sticks
Ribbon
A4 sheet
Ruler
scissor
Knife
Wax paper
Cello-tape
Black paint
Marker
Pattern
![Collages26.jpg](/proxy/?url=https://content.instructables.com/FBL/SM5U/I1C3VLH6/FBLSM5UI1C3VLH6.jpg&filename=Collages26.jpg)
Draw pattern of mask as your wish. Mark the end and centre points with ruler and start drawing from centre point.
or
You can download it from internet. There are tons of templates available.
Draw With Hot Glue
![Collages27.jpg](/proxy/?url=https://content.instructables.com/FHL/P3PE/I1C3VLI4/FHLP3PEI1C3VLI4.jpg&filename=Collages27.jpg)
Stick all corners of pattern sheet in flat surface.
Place the wax paper over it and cellotape it.
Now trace the black sketch with hot glue gun. Make sure that you traced all the curves and lines.
Finally, cut 2 pieces of ribbon approximately 10" each and glue it on both ends.
Paint It
![Collages28.jpg](/proxy/?url=https://content.instructables.com/FN6/JYST/I1C3WNN0/FN6JYSTI1C3WNN0.jpg&filename=Collages28.jpg)
![Collages29.jpg](/proxy/?url=https://content.instructables.com/FPB/ZEWY/I1C3VSCY/FPBZEWYI1C3VSCY.jpg&filename=Collages29.jpg)
Trim extra wax sheet and cut an hole for eyes.
Now paint the glue with black color ( or you can use any color)
Masquerade Mask is ready!