Modding Auto-reset to CP2102 USB to TTL Serial Adapter to Program Arduino Pro Mini Like the FTDI Board

This USB to TTL Serial board based on the CP2102 chip, is readily available on eBay. And it can be used to program the Arduino Pro Mini and others which don't have USB on board. But it's not as convenient as the FTDI board sold by spark fun.

The pin out of the USB adapter and the Arduino doesn't match.
And the USB adapter doesn't have a auto-reset pin, so every time you have to hold reset at the exact time you hit upload a new code.

So I will address both of this issues here.

CP2102 Datasheet: https://www.sparkfun.com/datasheets/IC/cp2102.pdf

Drivers: http://www.silabs.com/products/mcu/pages/usbtouart...

Just cut a piece of perfboard with a sawtooth, and sand the edges to make it smooth.

Then I used piece of steel wool to remove the oxidation layer of the copper to make soldering easier.

Using the same pin header removed earlier, I inserted it from the bottom and then soldered it on the top.

Then I trimmed the rest of the pin header with a old scissors and soldered it to the bottom side.

This makes a very solid connection.

I savaged a wire from a cheap broken pair of earphones, they are thin enameled stranded wire. I untwisted one of then and cut just one little strand to the next step.

To use the auto-reset to upload code from the arduino IDE, we will use the DTR pin on the CP2102 chip.

On the data sheet we can find the pin-out.

Unfortunatelly this board does not have this pin routed, bute there's a workaround.

Using the very thin enameled wire, burn the tip of the wire applying tin to it using the iron to remove the varnish coating.

Then remove all solder from the tip of your iron.

This can be done with naked eye, but if you find it difficult some magnification may help here.

place the enameled wire on to of the pin 28, there's no solder pad, it is small but it's there.

Them just touch the iron on top, it will solder instantly. (I got it on the first attempt)

Don't move it, it's very fragile, so just add a drop of super glue on the wire to give some mechanical strength. Do not put glue on top of the pin, glue the wire to a empty area on the board.

If you need some idea on soldering tiny stuff, I have a video repairing a iPad flex cable, with similar dimensions. Note that the video is great magnified.

Some photos of the final result.