My Skateboard
My skateboard introduction： I through tinkercad website, using cylinder, cube and other connectors, through the establishment of models, to complete my skateboard design.
Make the Radian Part of the Front and Back End of the Skateboard
First, use three transparent cubes to intercept a cylinder ,
and then cut the arc . Then connect the arc with the cuboid and make it.
Assembly Connecting Slide
one half skateboard is connected by arc and cuboid, and the other half skateboard is copied to form a skateboard plane
Mounting Connector
Install two bearings under the surface of the slide plate to hold the roller shaft in place.
Complete Installation
Install a pulley on the pulley shaft to make a pulley.