Phone Stand

The item I made is a phone stand. I made this stand because every night before I go to bed I put my phone for charging and leave it on my desk. However, due to the mess up of cables I have, my phone always ends up falling off and sometimes even stop charging. With this phone stand, my phone can stay sturdy and upright, and it also has a hole so that a charger can pass through, which solves my problem of my phone falling down every night. This also provides an easier access to my phone at all times because it is sitting upright.

3D print filament

Make a new sketch on the top plane, sketch a 3 inch by 5 inch rectangle, and extrude it by 0.20 inches.

Make a new sketch on the front plane, sketch a 0.50 inch by 3 inch rectangle, and then revolve it around the z axis.

Make a sketch on the right plane, and sketch the above shape at whichever angle, and symmetrically extrude it by 1.5 inches.

On the surface shown above, make a new sketch. Sketch a short rectangle that is possible for a phone charger to pass through. Then, extrude cut it through the shape.

Sketch a small circle on the top face of the stem. Then, extrude it by 0.60 inches can put a taper angle of -40.0 so that it doesn't cut in with the other features of the project.