Small Lipo Battery Charger

by FINNBOBTHEGREAT in Circuits > Tools

54 Views, 0 Favorites, 0 Comments

Small Lipo Battery Charger

20260413_215612502_iOS.jpg

A small 3D Printed casing to house a TP4056 charging module and screw terminal block to wire into a battery.

Supplies

20260413_220424804_iOS.jpg
  1. 3D Printed Case
  2. TP4056 Charging module
  3. 2 Port Connector Block

Downloads

Battery Charger.stl

Steps

20260413_220357015_iOS.jpg
  1. Print the casing
  2. Cut the wire to the correct length.
  3. Slide them under the arch
  4. Solder the wires to the B+ and B- Pads on the TP4056
  5. Solder the other end of the wires to the connector block
  6. Slide the TP4056 into the housing
  7. Slide the connector block into place
  8. Slide the top onto the housing