Tree of Life Wire Pendant

I was inspired for this pendant by this instructable:

https://www.instructables.com/id/How-to-make-a-Tree-Pendant/

I searched google images for tree of life pendant and then I decided to make my own version. After a bit of trying, this is what I came up with. I hope you like it!

To make this project, you'll need the following:

If you have an old keychain, remove everything from the ring.

Make sure the wire is longer than the diameter of your ring. Cut eight pieces.

Start by wrapping all eight pieces of wire together.

Unwrap one of the pieces of wire till a bit above the middle. Repeat for the other seven pieces of wire.

Do the same at the bottom. The piece that is still twisted is the trunk.
Divide the roots of the tree in four groups of two. Twist the two wires together to make four roots.

As you can see, the trunk is a bit too long. I lowered the branches by unwrapping them a bit and then wrapping them lower.

Take your ring and decide where to place the tree. I decided to go for a place close to the middle.
Wrap the endings of the roots around the ring as shown in the picture.

First, straighten the branches a bit and bend them in the position that you like.
Add beads to them and wrap the end around the ring.

Your pendant is finished now.

Start with a piece of cord that fits over your head, even when knotted. Knot the ends together.
Put the other end of the ord (so not the knotted side) through the pendant. Put the end with the knot through the part that's already through the pendant (you know what, just look at the pics)

Now your necklace is finished!

I hope you liked this project :)