"True Trigger" Addition to One Shot Knex Gun/Pistol by Bannana Inventor

This Instructable was made to show you how to put a real trigger on one of the earlier guns I made. Here is a link you will need before you begin this Instructable, however if you have already made this gun you may continue.

Before you begin you must remove the old trigger of the gun you will not need it anymore.
Build the two objects in the picture. You will need the following:

8 gray single connectors.
6 white/black/gray rods.
3 blue spacers.
2 blue rods.
2 green rods.
2 red connectors.
1 orange connector.

Connect the trigger as shown.

Connect the trigger to the gun as shown, one part goes on the original block pin, and the other goes on the place were the old trigger was. Don't forget to attach the tan piece on the block pin to hold it in place.

Thank you for viewing this Instructable.
:D :P :) :@