Vacuum Clamp


simple print suction clamp that requires compressor or vacuum pump to run
Supplies
This is a demo:
https://www.youtube.com/watch?v=eydZuZelm_g
Bill of materials:
- M3 x 10mm (x8) for attaching the top
- M3 x 22mm (x2) to attach the valve
- Male Thread Quick Release Connectors Coupler 1/4" BSP (depends on your setup)
- 6mm Tube to 1/4 BSPT Push Lock
- 1/4 Turn 6mm Pipe Fitting Coupler Valve (I designed the holes for this specific
- Air Compressor Hose Pipe (6mm OD)
- PC6-01 Pneumatic Connector
- Solid Foam Rubber Round at 8mm
- Vacuum generator (if you are using a compressor)
Render animation:
https://www.youtube.com/watch?v=oPc6ZC5L1l8
Compressor Vs Vac Pump Setup


The supplies are a bit different depending if you have a compressor or a vac pump.
3D Printed Parts
These parts are for 3D printing. The Vac-body-01 requires support turned on. This fits on prusa MK3, MK4, Bambu Lap P1 and so on.
Assembly

Connect with tubes according to diagram above.