Wedge and Feathers for Rock Splitting (or Plug and Feather)
by mandamados in Workshop > Metalworking
11191 Views, 7 Favorites, 0 Comments
Wedge and Feathers for Rock Splitting (or Plug and Feather)
The image of wedge and feathers is taken from the internet. The dimensions of the original tool are different.The tool is for a hole with diameter 22mm.
Wedge
For the wedge I used a piece of steel, 1,5 cm thick. Then I cut a piece 20 cm in length
Dimensions of the Wedge
The biggest part of the wedge is 24mm and the smallest is 7mm. Mark the wedge with a pencil and cut it.
Cutting the Wedge
Cut the wedge with an angle grinder
Final Piece of Wedge
Picture of the final piece of wedge. The final piece of the wedge should be like this
Feathers
For the feathers I used construction steel bars 19 cm in length. Cut 2 of these.
Dimensions of the Feathers
The diameter of the two feathers should be 22mm. To achieve this, it's better to cut the steel bars with an angle.
The Final Piece
The final piece should be like this. Cut other 2 or 3 to break the rock easily.
The Results
